Cart

How to Change Keycaps (Without Breaking Anything)

Swap one keycap or the whole set safely: the right puller, the big keys with stabilisers, hot-swap boards, and how to clean caps while they are off.

Changing keycaps takes about ten minutes for a whole board and needs one cheap tool. The only keys that need any care are the long ones. Here's the whole job.

What you need

  • A wire keycap puller. The two loops slide down either side of the cap and grip it underneath, so it lifts straight up without scratching. The flat plastic ring pullers that come free with keyboards work too, but they can mark the edges. Keycap pullers.
  • Your phone, to take a photo of the board first. You will want it later.
  • Optional: a bowl of warm soapy water and a towel, if the caps are coming off anyway.

Taking keycaps off

  1. Unplug the keyboard (or switch it off if it's wireless), so you don't type a novel into whatever's open.
  2. Photograph the layout. Especially the bottom row and the keys around Enter.
  3. Pull straight up. Hook the puller under opposite sides of the cap and lift with a gentle wiggle. Don't twist or lever it sideways; that's how stems get stressed.
  4. Long keys go slowly. Spacebar, Enter, both Shifts and Backspace sit onstabilisers: small wire bars that stop them rocking. Lift both ends evenly. On some boards the stabiliser wire clips into the cap. If it resists, look underneath before you pull harder.

Hot-swap boards: if the switch comes up with the cap, don't panic. Pull the cap off the switch, check the switch's metal pins are straight, and push it back into its socket until it clicks flat. Use a keycap puller for caps, and the switch puller only for switches.

Cleaning while they're off

Drop plastic caps (ABS and PBT) into warm water with a little dish soap and leave them to soak for half an hour, then give them a swish and rinse. Dry them completely, overnight on a towel, before they go back on, because water in a switch is the one thing that ruins this job. Resin and hand-painted caps get lukewarm water and a soft brush only. Never use the dishwasher; hot water warps plastic. While the board is bare, a soft brush or a puff of air clears the crumbs.

Putting keycaps on

  1. Line up the cross. Turn the cap so its "+" socket matches the switch, set it on top, and press straight down until it seats with a small click. No need to lean on it.
  2. Check the row. On a sculpted set, each row is shaped differently. Most sets mark the row (R1โ€“R4) inside the cap, or follow your photo.
  3. Stabilised keys last. Line up the stabiliser posts at each end first, then the middle, and press down evenly across the whole key. Then tap it at both ends. If one end sticks or won't spring back, it's not seated on a stabiliser post; lift it and try again.
  4. Test every key before you put the tools away. Our sister shop Ed's PCs has a free keyboard tester that lights up each key as you press it.

Before you buy a new set

Check it'll fit first. Stem, layout and the bottom row are covered in will these keycaps fit my keyboard? And if you're just after a few fun keys rather than a whole set, the individual keycaps go on in about four seconds each.

Something broken, sticky or full of cordial? That's a repair, not a keycap swap. We fix keyboards too.

More guides